Cue Editor
Cue EditorPrototype

Mixer

Track info

Markers

How a fit works

  1. The music is written in 4-bar phrases. Each one is marked with the phrases and endings that can follow it.
  2. The editor finds a path through those phrases that lands one of the recorded endings on your hit.
  3. It back-times the start. The cue begins partway into the intro and fades up, the way a music editor lands a cue by hand.
  4. Cuts fall on downbeats, between bars that match in chord and pattern, so a cut sounds like the song went there.
  5. Each cut gets a reverb tail. Over the last 3 seconds, whatever is about to stop feeds a reverb and rings out.

Nothing is generated and nothing is time-stretched. Every note is the composer's recording.

Controls

SpacePlay or pause HomeReturn to the start LLoop ClickClick the ruler or a lane to move the playhead DragDrag the yellow hit flag to move the hit point. Drag a knob or fader up and down; hold Shift for fine moves Double-clickReset a knob or fader MMute a stem, on its track or its channel SSolo a stem

Simple view keeps to the essentials. Full view adds the stem timeline, energy, cut tails, loop and the mixer. On the timeline, a pale wedge after a cut is its reverb tail. Lo cut and Hi cut are 12 dB/octave filters. The EQ is a low shelf at 120 Hz, a bell at 1 kHz and a high shelf at 7 kHz. Separate stems export with their EQ, pan, fader and tail, at the level they were delivered, without the master fader or limiter.

About this build

A prototype. Song 2 is built from seven stems and three recorded endings, streamed here as MP3 copies of the 24-bit WAVs. Song 1 is cut on its bar lines from a stereo MP3.